Power Electronics and Energy Systems · Inverters, PWM, and three-phase conversion
A separately excited DC machine is driven from a stiff DC bus V_dc=300 V by a bipolar…
Problem
Power Electronics and Energy Systems practice problemA separately excited DC machine is driven from a stiff DC bus by a bipolar PWM H-bridge. The armature back-EMF is and the armature resistance is . Armature inductance may be neglected in the PWM-period average. The machine is generating: a regenerative current flows from the motor into the bridge. Switching loss is neglected, so the bridge is an average power-conserving voltage transformer from bus to armature.
Bipolar PWM applies for duty of each carrier period and for the complementary interval, so the average armature voltage isWith the stated generating current, Kirchhoff's voltage law on the armature is .
1. Prove . Invert the bipolar map and
prove2. Prove the mechanical conversion , the copper
loss , and the power returned at the armature terminals . Confirm the ledger
.
3. Prove that the average current returned into the
bus is4. Audit both sentences: (i) “regeneration requires , hence
”; (ii) “the bus current equals the armature current , or else .”
Do not replace the average bipolar map by a hard-switching conduction / transition / recovery loss ledger, do not invoke three-phase SVPWM sector dwell, and do not discuss transformer reset or flux walk.
Hint
HintGenerating KVL is , not . The result is still well above zero.
Check your work
Work the problem yourself first. Then open it in Training to check your answer and read the full worked solution.
The answer check and full solution for this problem come with ProofAnvil Practice membership ($19 USD monthly). See membership. Or start with the free Power Electronics and Energy Systems sample problem: Try the free sample problem.
More Power Electronics and Energy Systems practice problems
- A lossless synchronous buck (complementary high-side and low-side switches, no diode…Nonisolated DC-DC conversion in continuous and discontinuous modes
- A dual-active-bridge converter joins a primary dc bus V₁=400 V to a secondary dc bus…Isolated converters, transformers, and magnetic components